Process-property Relationships in Fused Filament Fabrication of 17-4PH Stainless Steel: Effects of Printing Parameters on Tensile Strength, Shrinkage, and Defect-sensitive Behavior

Authors

  • György Ledniczky
    Affiliation
    Department of Innovative Vehicles and Materials, GAMF Faculty Engineering and Computer Science, John von Neumann University, H-6000 Kecskemét, Izsáki st. 10., Hungary
  • Adrián Bognár
    Affiliation
    Department of Innovative Vehicles and Materials, GAMF Faculty Engineering and Computer Science, John von Neumann University, H-6000 Kecskemét, Izsáki st. 10., Hungary
  • Krisztián Kun
    Affiliation
    Department of Innovative Vehicles and Materials, GAMF Faculty Engineering and Computer Science, John von Neumann University, H-6000 Kecskemét, Izsáki st. 10., Hungary
https://doi.org/10.3311/PPtr.40046

Abstract

This study investigates the effect of selected Fused Filament Fabrication parameters on the tensile behavior and dimensional change of 17-4PH stainless steel specimens produced from BASF Ultrafuse filament. Layer height, printing speed, and infill angle were evaluated using a Taguchi-based experimental design, while the printed parts were subsequently subjected to catalytic debinding and sintering. Tensile testing of the as-sintered specimens showed that the best-performing parameter combination reached 802 MPa, corresponding to approximately 80% of the tensile strength reported by the material supplier. The statistical analysis identified layer height as the most influential factor, followed by infill angle, whereas printing speed had a smaller effect within the investigated range. In addition to the primary tensile and shrinkage evaluation, supplementary dimensional, density-related, and fracture-surface observations were used to support the interpretation of the results. These findings indicate that the final mechanical response cannot be explained solely by nominal printing settings, but must be understood through their effect on green-part integrity, densification, shrinkage, and internal defect formation during post-processing. Overall, the results show that the performance of extrusion-based 17-4PH stainless steel parts is governed by the combined effect of deposition strategy and thermal treatment, and that reliable parameter selection can significantly improve the mechanical quality of sintered components.

Keywords:

Fused Filament Fabrication, metal FFF, 17-4PH stainless steel, shrinkage, process parameters

Citation data from Crossref and Scopus

Published Online

2026-11-16

How to Cite

Ledniczky, G., Bognár, A., Kun, K. (2026) “Process-property Relationships in Fused Filament Fabrication of 17-4PH Stainless Steel: Effects of Printing Parameters on Tensile Strength, Shrinkage, and Defect-sensitive Behavior”, Periodica Polytechnica Transportation Engineering. https://doi.org/10.3311/PPtr.40046

Issue

Section

Articles